How to Embroider a T-Shirt by Hand (Without Puckering)
Step-by-step guide to hand embroidering a t-shirt: stabiliser, hooping a knit, transferring the design, stitch choice, finishing the back and washing.
By Ayoub Farid · · 2 min read
T-shirt fabric stretches, which is what makes it comfortable and what makes it tricky to embroider. The secret is a stabiliser. With one, embroidering a tee is as easy as stitching on cotton.
What you need
- A cotton t-shirt (pre-washed)
- Iron-on (fusible) stabiliser or interfacing
- Water-soluble stabiliser with your design printed on it (optional, for dark tees)
- A 10–15 cm hoop
- Floss and an embroidery needle
- Sharp scissors
Step 1: Pre-wash the shirt
So it doesn't shrink and pucker your embroidery later.
Step 2: Add stabiliser to the inside
Cut iron-on stabiliser slightly bigger than your design and iron it to the inside of the shirt, behind where you'll stitch. This turns the stretchy knit into a firm surface.
Step 3: Transfer the design
- Light tee: trace with a washable pen.
- Dark tee or detailed design: print onto sticky water-soluble stabiliser and stick it on the front.
See how to transfer embroidery patterns.
Step 4: Hoop one layer
Slide the inner ring inside the shirt so only the front layer is in the hoop. Tighten so the fabric is smooth and firm, but don't stretch it. A stretched knit springs back after unhooping and puckers.
Step 5: Stitch
- Use 2–3 strands.
- Choose line stitches: back stitch, split stitch, chain stitch, stem stitch.
- Keep tension relaxed; pulling tight is the main cause of puckering on knits (tension guide).
- Avoid large satin fills; small ones are fine with stabiliser.
Step 6: Finish
- Secure thread ends by weaving under stitches on the back.
- Rinse away water-soluble stabiliser if used.
- Trim excess iron-on stabiliser around the design.
- Optional: iron a soft piece of interfacing over the back so stitches don't rub your skin.
Step 7: Wash with care
Inside out, cold, gentle cycle, air dry. More in washing embroidery.
Design ideas
A small wildflower sprig on the chest, initials near the hem, a line-drawing pet, a short word. See name embroidery ideas and wildflower embroidery. For other garments, read embroidery on clothes.
Common t-shirt embroidery problems
| Problem | Fix |
|---|---|
| Puckering around the design | More stabiliser, looser tension, don't stretch in the hoop |
| Stitches look sunken | Use 3 strands and slightly bolder stitches |
| Back scratches | Iron soft interfacing over the stitches |
| Design shifts while stitching | Tack the stabiliser down before hooping |
Start with a small design on an old tee to practise before stitching a favourite shirt.
Frequently asked questions
How do I stop my t-shirt embroidery from puckering?
Use an iron-on stabiliser on the inside, don't stretch the fabric in the hoop and keep tension relaxed.
Can I embroider a t-shirt without a stabiliser?
You can, but it will likely pucker. A stabiliser makes it much easier.
What stitches are best for t-shirts?
Line stitches like back, split, chain and stem stitch. Avoid long satin stitches.
Will embroidery on a t-shirt last?
Yes, with secured ends and gentle washing.