hoopie

How to Start and End Embroidery Thread (With and Without Knots)

Four ways to start embroidery thread (knot, waste knot, loop start, away knot) and how to end it neatly on the back so nothing unravels or shows.

By Ayoub Farid · · 2 min read

How you start and end your thread decides whether your stitches stay put, whether the back of your hoop is neat, and whether lumps show through on the front. Here are the four common ways to start and the two ways to finish.

Ways to start

1. A simple knot

Tie a small knot at the end of the thread and come up from the back. Easiest for beginners. Downsides: knots can make lumps under the fabric (visible when framed tightly) and can pull through loose-weave fabric.

2. Waste knot

  1. Tie a knot and go down from the front, about 5 cm away from where you'll start, in the direction you'll stitch.
  2. Stitch toward it, so your stitches cover the thread on the back.
  3. When you reach it, snip the knot off the front. The thread is now secured under your stitches.

Neat and secure, and no knots left behind.

3. Loop start (for even strand counts)

  1. Take one strand twice as long as you need, fold it in half and thread the two cut ends through the needle. You now have 2 strands with a loop at the end.
  2. Come up from the back, make your first stitch, and on the back pass the needle through the loop.
  3. Pull gently. The loop locks the thread.

The neatest start for 2, 4 or 6 strands.

4. Away knot

Like a waste knot, but placed further away, outside the design. After stitching, snip the knot, rethread the tail and weave it in on the back.

Ways to end

1. Weave under stitches (best)

On the back, slide the needle under 3–4 nearby stitches, ideally doubling back once, then trim close. Secure and flat.

2. A small knot on the back

Make a tiny stitch on the back, pass the needle through the loop before tightening, repeat once, and trim. Quick but slightly lumpier.

Rules for a tidy back

  • Don't carry thread more than about 2 cm across the back between areas. On light fabric, it shadows through. End and restart instead.
  • Trim tails to about 5 mm so they don't tangle with new stitches.
  • Dark thread near light areas: end it carefully so it doesn't show through.

More in how to keep the back of embroidery neat.

Which method should I use?

SituationBest start
Your very first stitchesSimple knot
Hoop art you'll frameWaste knot or loop start
Clothes and items you'll washWaste knot + weave to end (secure)
Even strand countsLoop start

Frequently asked questions

Should I use knots in embroidery?

Knots are fine for beginners and practice pieces. For finished work, waste knots and loop starts keep the back flat.

How do I stop my embroidery from unravelling?

End by weaving the thread under 3–4 stitches on the back, doubling back once before trimming.

What is a waste knot?

A temporary knot on the front of the fabric, away from the start, that you cut off after your stitches have covered and secured the thread.

How long should the tail be when I end?

Trim to about 5 mm after weaving it in.

Keep reading